Rust finishing kit

With these two products together, you can achieve a truly rusty color effect on almost any degreased surface.
Thoroughly degrease the surface and avoid direct contact with the surfaces to be painted (otherwise, grease will spread through your fingers).
A good comparison for use: component A and component B!
With component A: cover the shared areas with paint product A.
Then activate the same areas with product A using the activator product B.
After 10 minutes, you will see the first signs of oxidation (rust).
A minimum of 2 or 3 coats of product B are recommended. Each coat of product B over the other creates a beautiful color variation. This product has a shelf life of approximately 6 minutes after the first use.
The two components are exposed to heat, cold, and different humidity levels, which will result in different discolorations. This also creates a natural tint!
Tip! If component A starts to thicken or is too thick to use, dilute it with pure water and shake well again!
Tip 2! Do not use the product when it is too cold or too hot/outside in the sun. High humidity is better than too low humidity, because then the activator dries too quickly and cannot work on the A component.
Tip 3! Multiple layers of well-shaken A component can be painted over activated parts if you reactivate them. Achieving the same color at different times is not possible due to different humidity and temperature conditions.

Scale: all scales

Also for War Game